Installing Battery - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

Mounting Wall Station
CAUTION: Over tightening the upper
Tools Needed:
screw could deform plastic case and may
Phillips Head
affect operation.
Screwdriver
Once wall station is snuggly onto lower
screw, install upper screw. Do not over
tighten.
23
Remove the Battery Cover (right-hand side
Tools Needed:
of wall station) by disengaging the battery
None
cover's Lower Clip. Install two AAA
batteries into the wall station observing
the polarity, (+) and (-), of both batteries.
After about five seconds, the Up/Down red
LEDs will begin to blink momentarily every
1/2 second. Re-install the Battery Cover
by first inserting its top into the wall
station then inserting and securing its
bottom.
Apply entrapment label in a convenient
location next to the Wall Station. Use
mechanical fasteners if adhesive will not
adhere.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
(Continued)

Installing Battery

Phillips Head Screw
Wall Station
(2) AAA Batteries
Battery Cover
Lower Clip
12