Mounting Disconnect Handle Bracket; Attaching Disconnect Handle - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

13
Mark a location on the right jamb, 6 feet
Tools Needed: Tools Needed:
above the floor to mount the Disconnect
Pencil
Handle Bracket. Align top of the Bracket
Tape measure with the mark. Drill pilot holes using 1/8"
drill bit. Fasten Bracket to the jamb with
Drill with 1/8" bit
(2) 1/4 x 1-1/2" Lag Screws.
7/16" Socket
Driver
14

Attaching Disconnect Handle

Start the #6-20 x 1/2" Screw into the
Tools Needed:
Handle. Thread the Disconnect Cable
Phillips head
through the top of the Handle Bracket and
screwdriver
then the Handle. Locate the Handle in upper
position of Handle Bracket.
Wire cutters
Remove all cable slack between the Opener
and the top of the Handle Bracket. Pull the
Disconnect Cable only enough to remove the
Cable's slack (pulling the Cable more
could cause Opener to disconnect from
the Torsion Tube).
NOTE: If Motor disconnects from Torsion
Tube refer back to step 8.
Tighten #6-20 x 1/2" screw into the handle
until snug, and then tighten screw an
additional 1 to 1-1/2 turns to secure cable
to handle. Trim off excess cable from bottom
of the handle.
Apply Emergency Disconnect Label next
to the Disconnect Handle Bracket. Use
mechanical fasteners if adhesive will
not adhere.
Note: Pulling the Disconnect Handle down
and hooking it to the bottom of the
Disconnect Handle Bracket will place the
door in manual operated position. When
releasing the Disconnect Handle from the
manual operated position to the motor
operated position, the Disconnect Cable will
be slacked. This is normal. When the Opener
is activated the slack will be taken up.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
7
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Mounting Disconnect
Handle Bracket
Disconnect Handle
Right
Jamb
Motor operated position
Upper Position
#6-20 x 1/2"
Screw
Handle
Disconnect
Disconnect
Cable
Handle
Bracket
Opener
Bracket
FROM
FLOOR
Manual operated position
Emergency Disconnect Label
6'
FEET