Checking For Obstructions - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

30

Checking for Obstructions

Tools Needed:
Move the Emergency Disconnect Handle
to the Manual Operated Position (lower).
Ratchet wrench
WARNING
THE OPENER SHOULD ONLY BE
DISCONNECTED WHEN THE DOOR IS IN
THE CLOSED (DOWN) POSITION.
OTHERWISE, IN CASE OF WEAK OR
BROKEN SPRING(S), THE DOOR COULD
FALL, CAUSING SEVERE OR FATAL
INJURY.
Manually raise the door to the fully open
position. Then manually lower the door
to the fully closed position.
If no obstructions interfere with the door
when manually opened and closed,
proceed to Step 31.
If an object, such as a ceiling beam,
obstructed the door from opening
completely, proceed to Step 31 then 33
to set a custom upper limit setting
during the install routine.
If there is interference between the top
of the door and the Opener's housing,
try repositioning the Top Bracket as far
up as possible.
CAUTION! Complete repositioning the
top bracket on one side of the door,
before beginning the other side.
The Top Brackets are located on the
garage door top section (closest to the
ceiling). Loosen the nuts from the Roller
Carrier (if present).
Remove the screws holding the top
bracket to the door section. Raise the
Top Bracket and re-attach. Re-align the
top roller in the track by moving the
roller carrier until the door section meets
the door stop. Tighten nuts.
Repeat for the other side.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
19
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Handle In Manual Door
Operated Position
" L" Top Bracket
Roller Carrier
Screws
"A" Frame Top Bracket
Screws
Roller Carrier
Bolts and Nuts
Horizontal Track
Top Roller
Horizontal Track
Top Roller