Positioning Safety Sensor Wall Mounting Brackets; Attaching Safety Sensor Wall Mounting Brackets - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

15
Positioning Safety Sensor
Wall Mounting Brackets
Select and mark with a pencil, a
Tools Needed:
mounting position no more than 5 inches
Pencil
above the floor to center line of wall
Tape measure mounting bracket. The Safety Sensors
should be mounted as close to the door
track or inside edge of the door as
possible to offer maximum entrapment
protection. It is very important that both
wall brackets be mounted at the same
height for proper alignment.
Use Steps 15-17 for installing sensors on
both sides of the garage door.
16
Attaching Safety Sensor Wall
Mounting Brackets
Tools Needed: : Drill pilot holes, using a 3/16" drill bit.
Using two 5/16 x 1-1/2" lag screw,
Drill with 3/16" bit
permanently mount the Wall Mounting
7/16" Socket Driver
Brackets to both door jambs. In some
installations it may be necessary to attach
7/16" Wrench
a wooden spacer to the wall to achieve
the required alignment.
Attach the "U" Brackets to the Wall
Mounting Brackets with 1/4-20 x 1/2"
Carriage Bolts, Washers and Nuts.
Insert the Bolts from the inside of the "U"
Bracket and hand tighten.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Wall Mounting
Bracket
Door Jam
Wall Mounting
5/16 x 1-1/2"
Bracket
Lag Screw
Nut
Washer
1/4-20 x 1/2"
Carriage Bolt
5"
U-Bracket
8