Programming Homelink System To The Torsion Idrive™ (Alternate) - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

NOTE: This Step can only be done on automobiles equipped with the
HomeLink System.
®
NOTE: Programming HomeLink
that is programmed to the Torsion idrive™ per Step 38.
IMPORTANT: Use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
learn the Transmitter, by using the vehicles instructions.
Note: Vehicle may need to be in accessory position when
programming. Check car owner's manual.
Note: HomeLink is a registered trademark of Johnson Controls.
®
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
29
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Programming HomeLink
® requires a Wayne-Dalton Transmitter
unit does not
®
System to the Torsion idrive™ (Alternate)
®
Programming/Training HomeLink
WARNING
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
WARNING
THE EMERGENCY DISCONNECT SHOULD ONLY BE USED WHEN DOOR
IS CLOSED.
1. Pull the Manual Disconnect to put the Opener in the manual
operated position.
2. Verify the HomeLink unit has an empty channel. Press the desired
®
HomeLink button and observe the LED. If it flashes slowly, the
®
channel is empty and ready for programming. If pressing the desired
channel/button causes the LED to blink rapidly, or come on without
blinking then this channel is already programmed. You either need to
choose a different channel/button on the HomeLink
Step 3 below.
3. OPTIONAL – To completely clear all channels on the HomeLink
press and hold the two outside buttons on the HomeLink
the HomeLink ® LED light begins to flash rapidly (approx. 20
seconds), then release both buttons. (Do not perform this Step to
train additional hand-held Transmitters.) Note: This operation erases
all previously learned Transmitters and you will need to re-teach any
other Transmitters to your HomeLink
4. Press and hold the Wayne-Dalton hand-held Transmitter's large
center button. The Transmitter's red Light Emitting Diode (LED) will
turn on. After 10 seconds the red LED will blink rapidly. Do not
release the button and proceed to the next Step.
5. Press the desired HomeLink
until Step 6 has been completed.
Note: It is important to immediately press the desired HomeLink button
as soon as the Transmitter's red LED blinks. If the red LED
subsequently turns on or off, ignore it, this is normal.
6. The HomeLink
® indicator light will be blinking during the training
operation. When the HomeLink
turns off (approx. 5 to 60 seconds), both buttons may be released.
The HomeLink indicator light flashing rapidly or turning off
®
indicates successful programming of the new frequency signal.
7. Press the red program button on the idrive™ Opener. The idrive™
unit will beep once, indicating that it is ready to learn.
Note: The idrive™ will remain in the learn mode for 30 seconds.
8. Press the HomeLink
® button used in Step 5 above for 1 to 3
seconds. The idrive™ will beep indicating a successful learn.
9. Return the Manual Disconnect to the motor open position.
10. Press the HomeLink
button once more to operate the door.
®
Unit
®
, or perform
®
unit until
®
unit.
®
button. Do not release either button
®
indicator light flashes rapidly or
®
unit,
®