Install Custom Upper Limit Routine; Adjusting Detent - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

33
WARNING
Tools Needed:
None
TO AVOID INJURY, NO ONE SHOULD
CROSS PATH OF A MOVING DOOR.
NOTE: If Step 32 was completed. Skip
this step.
NOTE: The door must be in its fully closed
position and the disconnect handle must
be in the motor operated position (upper
position) to initiate the install routine.
NOTE: Install routine will not run if safety
sensors are not aligned.
Press and hold the profile button for
five (5) seconds. The Opener will beep
twice, indicating the activation of the
install routine.
When the door moves to the desired
height, press the Up/Down button on
the wall station. The door will stop and
then lose completely.
Next, the door will go through one more
Up/Down cycle. Once this is complete, the
door limits are set and the installation is
complete.
X
34
Tools Needed:
The amount of pressure the Opener uses
to pivot the Motor downward is preset at
Flat Tip Screwdriver
the factory via the Detent Pin Adjustment
Screw.
Due to variations in door installations,
a Detent Pin Adjustment may need to
be made in order for proper pivoting of
the Motor.
IMPORTANT! For system security: the
Motor is designed to pivot down after the
door closes completely. If the motor does
not pivot or pivots too soon, the Detent
may need to be adjusted in order for the
door lock feature to work properly.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
21
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Install Custom Upper
Limit Routine

Adjusting Detent

Up/Down Button
Detent Pin
Adjustment Screw
Profile Button