Programming Transmitter - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

38 30

Programming Transmitter

WARNING
Tools Needed:
TO AVOID POSSIBLE SEVERE OR FATAL
INJURY, MANUALLY DISCONNECT THE
OPENER, USING THE EMERGENCY
HANDLE PRIOR TO PROGRAMMING
REMOTE CONTROLS.
WARNING
THE OPENER SHOULD ONLY BE
DISCONNECTED WHEN THE DOOR IS IN
THE CLOSED (DOWN) POSITION.
OTHERWISE, IN CASE OF WEAK OR
BROKEN SPRING(S), THE DOOR COULD
FALL, CAUSING SEVERE OR FATAL
INJURY.
a. Pull the Emergency Disconnect Handle
to the Manual Door Operated Position
(lower position).
b. On the front cover of the Opener,
press and release the red program
button: The Opener will beep once,
indicating activation of the program
mode. The Opener will remain in
program mode for 30 seconds. If at
the end of 30 seconds the Opener has
not learned an RF device, the Opener
will beep once; indicating the learn
mode is no longer active.
c. Press and hold the desired Transmitter
button until; the Opener beeps once.
The Transmitter is now programmed.
No beeping response of the Opener
during the Transmitter programming
indicates a programming failure. Repeat
programming a-c.
d. Return the Emergency Disconnect
Handle to the Motor Operated Position
(upper position).
NOTE: The first transmitter command
after programming will only move the
door through a six inch up/down cycle.
Normal door operations will occur on the
second use of the transmitter.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Handle In Manual
Door Operated
Position
a
b
c
Large Button
Red Program
Motor in
Up Position
d
Handle In Motor
Operated Position
Button
24