Programming Homelink System To The Torsion Idrive™ (Primary) - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

NOTE: This Step can only be done on automobiles equipped
with the HomeLink System.
®
NOTE: Programming HomeLink
Transmitter that is programmed to the torsion idrive
Step 38.
IMPORTANT: Use the programming instructions provided with
your vehicle first. Follow these instructions if the HomeLink
unit does not learn the Transmitter, by using the vehicles
instructions.
NOTE: If Primary Programming does not work then use the
Alternate Procedure on next page.
Note: Vehicle may need to be in accessory position when
programming. Check car owner's manual.
Note: HomeLink
® is a registered trademark of Johnson
Controls.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Programming HomeLink
requires a Wayne-Dalton
®
per
®
®
System to the Torsion idrive™ (Primary)
®
Programming/Training HomeLink
WARNING
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
WARNING
THE EMERGENCY DISCONNECT SHOULD ONLY BE USED WHEN DOOR
IS CLOSED.
1. Pull the Manual Disconnect to put the Opener in the manually
operated position.
2. Verify the HomeLink unit has an empty channel. Press
®
the desired HomeLink button and observe the LED. If it flashes
®
slowly, the channel is empty and ready for programming. If pressing
the desired channel/button causes the LED to blink rapidly, or come
on without blinking, then this channel is already programmed. You
either need to choose a different channel/button on the HomeLink
or perform Step 3 below.
3. OPTIONAL – To completely clear all channels on the HomeLink
press and hold the two outside buttons on the HomeLink
the HomeLink LED light begins to flash rapidly (approx. 20
®
seconds), then release both buttons. (Do not perform this Step to
train additional hand-held Transmitters.) Note: This operation erases
all previously learned Transmitters and you will need to re-teach any
other Transmitters to your HomeLink
4. Hold the end of the Wayne-Dalton hand-held Transmitter
approximately 1 to 3 inches away from the HomeLink
keeping the HomeLink LED light in view.
®
5. Press and hold the desired HomeLink
should flash slowly (indicating empty channel). Continue holding the
HomeLink ® button and press and hold the large button on the
Wayne-Dalton Transmitter for approximately 3-5 seconds. The
HomeLink LED should now blink rapidly, indicating a successful
®
learn operation. Release both buttons, and proceed to Step 6 below.
Note: If this procedure is unsuccessful, perform Alternate procedure on
next page.
Teaching HomeLink to the idrive
®
6. Press the red program button on the idrive
will beep once, indicating that it is ready to learn.
Note: The idrive will remain in the learn mode for
®
30 seconds.
7. Press the HomeLink button used in Step 5 above for 1 to 3
®
seconds. The idrive ® will beep indicating a successful learn.
8. Return the Manual Disconnect to the motor operated position.
9. Press the HomeLink button once more to operate the door.
®
Note: The first transmitter command after programming will only move
the door through a six inch up/down cycle. Normal door operations will
occur on the second use of the transmitter.
Unit
®
®
unit,
®
unit until
®
unit.
®
surface,
®
channel/button. The LED
®
Motorhead Unit
®
® Opener. The idrive ® unit
28
,