Positioning Wall Station; Mounting Wall Station - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

21

Positioning Wall Station

Tools Needed:
TO PREVENT POSSIBLE INJURY, INSTALL
Tape Measure
ALL WALL CONTROLS OUT OF THE
Drill
REACH OF CHILDREN AND IN A
3/32" Drill Bit
LOCATION WHERE THE OPENER CAN BE
SAFELY ACTIVATED, WHILE KEEPING
3/16" Drill Bit
DOOR IN SIGHT. DO NOT MOUNT THE
( For Anchors)
CONTROLS NEAR OR NEXT TO GARAGE
DOOR.
Locate a convenient place to mount Wall
Station. To keep Wall Station out of the
reach of children, mount at least 5 feet up
from the floor.
If fastening into drywall or concrete, use
anchors provided. Using a 3/32" drill bit
and the drilling template located on page
34, drill the two mounting holes. Drill
3/16" holes if using anchors.
NOTE: Make sure mounting surface
is flat.
22
NOTE: The wall station can be mounted
Tools Needed:
to a NEMA standard electrical device box
Phillips Head
or directly to any wall surface. No wiring is
Screwdriver
required. If mounting to a NEMA electrical
device box use machine thread screws
provided in place of the wood screws. No
drilling is required. If high voltage wiring is
contained in the box a standard NEMA
solid faceplate must be installed between
the box and the wall station.
Install lower screw leaving 3/16" of the
threads exposed. Slide wall station
Keyhole slot onto the lower screw.
Wallstation should slide onto screw,
providing a snug fit. If necessary,remove
wall station and loosen or tighten lower
screw.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
11
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
WARNING

Mounting Wall Station

Wall
Keyhole Slot
3/16"
5' Min
Phillips Head Screw