Connecting Safety Sensor Wires To Opener; Organizing Safety Sensor Sender And Receiver Wires - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

19
Connecting Safety Sensor
Tools Needed: Expose the Terminal Block by sliding the
right hand Gear Assembly to the right.
Wire cutters
Using a pair of Needle Nose Pliers, gently
Flat Tip
pull terminal block from right hand side of
Screwdriver
opener. Separate wire ends and strip
Needle Nose
about 1/2" of the insulation off each of
Pliers
the wire ends.
Using the Flat Tip Screwdriver to loosen
the screw above Hole #1 of the Terminal
Block. Insert both sender and receiver
solid white wires into Hole #1. Tighten
the screw above Hole #1 till both sender
and receiver solid white wires are
secured tightly. Insert both sender and
receiver wires (white with black stripe)
into Hole #2 by the same process. After
wires are secured in Terminal Block, snap
Terminal Block back in right hand side of
opener.
20
Organizing Safety Sensor
Sender and Receiver Wires
Tools Needed:
IMPORTANT! Keep Safety Sensor Wires
away from moving parts.
3/8" Wrench
Keep the Safety Sensor Wires straight and
organized by wrapping them around the
backside of the Opener and securing
them using the Sensor Wire Clip
(adhesive backed). (Ensure the surface
the wire clip is attached to is clean and
oil free).
Position Right Hand Gear Assembly so it
is 1/8" from the Opener. Right Hand Gear
Assembly Square Head Bolt should be
hand tightened, then with a wrench
tighten 1 to 1 - 1/4 turns to secure Gear
Assembly.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Wires to Opener
Terminal Block
Needle Nose
Pliers
Flat Tip Screwdriver
Hole #2
White with
Black Stripe
Hole #1
Solid White
Wires
Sensor
Wire Clip
Right Hand
Gear Assembly
1/8"
Square
Head Bolt
Right Hand
Drive Gear
10