Maintenance; Battery Replacement For Wall Station; Battery Replacement For Transmitter - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

Erasing Remote Controls:
Caution: Manually disconnect the door from Opener using the
Emergency Disconnect Handle prior to erasing remote controls.
To clear programming of all remote control devices, press and
hold the Opener's Red Program Button for approximately 10
seconds. When the Opener beeps 3 times, all remote controls
are erased.
Multi Opener Light Control:
A single light fixture can be controlled by up to 6 Openers. Follow
the procedure outlined on Step 29 to program additional Openers.
Erasing Light Fixtures:
To clear programming of all Openers from a light fixture, press
and hold the Light Fixture Program Button for approximately
10 seconds. When the light fixture lamp and LED flash 6 times,
all Openers are erased.
Monthly Maintenance:
1. With door fully closed, move the Emergency Disconnect to the
Manual Door Operated Position and manually operate door. If
the door feels unbalanced or binds, have a qualified service
person make necessary adjustments or repairs to the door.
2. Perform the Obstruction Tests, see Steps 36 and 37.
3. Failure of door/Opener to respond to Transmitter or Wall
Station, may be due to a weak or dead battery. Press and hold
the Activation Button on either the Transmitter or the Wall
Station. If the LED does not light, this is an indication that the
battery is weak or dead. Replace the battery.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
31
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Customizing the Settings Continued
Program Button

Maintenance

Battery Replacement for Wall Station:

Remove the battery cover completely (right-hand side of wall station)
by disengaging the battery cover's lower clip, and remove the dead
batteries. Install the new batteries into the wall station observing
the polarity, (+) and (-), of both batteries. After a few seconds, the
Up/Down red LEDs will begin to blink every one second. If it is de-
sired to slow the LED blink rate refer to the operation section HOW
TO OPERATE THE WIRELESS WALL STATION. Re-install the battery
cover by first inserting its top into the wall station then inserting
and securing its bottom.

Battery Replacement for Transmitter:

Insert a coin and twist in the coin slot of the Transmitter and
remove cover to access the dead battery. Replace the battery,
being careful to match the positive (+) symbols on the Circuit
Boards with the battery.
NOTE: Some Transmitters use two CR2016 or equivalent
batteries while others use a single MN21 or equivalent battery.
NOTE: Dispose of dead batteries properly.
Red Program Button