Attaching Disconnect Cable Guide Bracket; Routing The Disconnect Cable - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

11
Attaching Disconnect Cable
Tools Needed: Position the flange of the Disconnect
Cable Guide Bracket just inside the Cable
Drill with 1/8" bit
Drum. Align the Disconnect Cable so it
7/16" Socket
remains parallel to the Torsion Tube.
Driver
When installing Opener, ensure there is at
least 6" of clearance between the cable
Tape Measure
end and the Cable Guide Bracket.
IMPORTANT! If the Disconnect Cable is
not aligned parallel to the Torsion Tube,
the disconnect operation will not function
properly.
Once the Disconnect Cable Guide Bracket
is aligned, drill pilot holes using 1/8" drill
bit. Secure the bracket to the jamb, using
(2) 1/4 x 1-1/2" lag screws.
12

Routing the Disconnect Cable

Route the Disconnect Cable behind the
Tools Needed:
counterbalance cable and through a
Drill with 1/8" bit
convenient hole or slot in the Flagangle.
Ensure the Disconnect Cable does not
rub against Counterbalance Cable.
If there isn't a hole available, it may be
necessary to drill a 1/8" diameter hole in
the Flagangle and/or end bearing bracket.
IMPORTANT! Verify the Disconnect Cable
is between the Counterbalance Cable and
the header/jambs. Route the Disconnect
Cable through Flagangle so the
Disconnect Cable hangs outside of the
track.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Guide Bracket
6"
Counterbalance cable
Flagangle
6