Installing Cable Keepers - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

24

Installing Cable Keepers

Carefully inspect the cables on your door.
Tools Needed:
If they are worn, frayed or broken, contact
None
a qualified door service company to
replace the cables before installing the
cable keepers.
WARNING
OPERATING A DOOR WITH FRAYED OR
Spacer
BROKEN COUNTERBALANCE CABLES CAN
RESULT IN SEVERE OR FATAL INJURY.
CONTACT A QUALIFIED DOOR SERVICE
COMPANY TO REPLACE FRAYED OR
BROKEN CABLES BEFORE INSTALLING
CABLE KEEPERS.
WARNING
DO NOT ATTEMPT TO LOOSEN OR
REMOVE BOTTOM BRACKETS. THEY ARE
UNDER EXTREME SPRING TENSION AND
CAN CAUSE SEVERE OR FATAL INJURY
Push Spacer on to the Roller Shaft
Roller
between the Bottom Bracket and Roller.
Use an additional Spacer if needed to
achieve min. 1/2" clearance.
If there is less than 1/2" clearance, loosen
Bottom Bracket
the lag screws attaching the track to the
wall and adjust the track for the 1/2"
clearance. Re-tighten the lag screws.
Position the right hand (black) cable keeper
assembly directly above the garage door
bottom bracket. The cable keeper
assembly must extend 1/8" past the end of
the door section. Ensure there is no more
than 4-1/2" from the bottom edge of the
door to bottom of Cable Keeper.
IMPORTANT! Right and left hand is
1/8"
always determined from inside the
building looking out.
4-1/2" Max
1/2" Min
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
13
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need