Pre-Installation Inspection - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

Pre-Installation Inspection

CAUTION! Do not install this Opener on your door unless the following
requirements are met.
Electrical Outlet
Electrical Outlet for
Light/Opener
F
A
Torsion Tube
1" Diameter
D
7" Min
Lock/Motor
Top of door
Pre-Installation Inspection
Before installing the torsion idrive
meets the following requirements. See the illustrations above as a
visual aid.
The torsion tube must be 1" in diameter.
A
There must be at least 30-3/8" of clear torsion tube between the
B
right (inside garage looking out) Cable Drum and end of left hand
gear. When installing the Opener, ensure there is at least 6" of
clearance between the cable end and the Cable Guide Bracket.
The Motor requires between 2-3/4" to 4-1/2" of clearance above
C
the top of the torsion tube.
There must be at least 7" of clearance between the top of the
D
door and the bottom of the torsion tube.
Required distance from the torsion tube to the header (mounting
E
surface) must be 2" to 2-7/8".
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
For Opener
Clearance for Motor
Opener, ensure your door system
®
E
Top View
B
30-3/8"
Two electrical outlets are recommended for the idrive installation.
F
One of these outlets needs to be located less than 6' from the
operator. The second outlet, for the light, can be located at a
position of your choice.
If in the event that an electrical outlet is not located within 6' of
the operator, contact a local electrician for further options.
Your door must not exceed 8' in height.
The torsion idrive Opener will only work on sectional doors.
®
Do not install on one piece doors.
Your garage door must be properly balanced (door must not be
heavy to lift, nor lift by itself). Maximum door weight (without
spring tension) must not exceed 400lb.
The torsion iDrive will not work on low headroom systems.
®
Horizontal tracks should be pitched 1" above level at rear of track.
Mounting Surface
2"- 2-7/8"
Min
Lock Adjustments
Cable
Drum
C
4-1/2"
2-3/4"
Cable Guide
Bracket
S Hook
Counterbalance
Cable
6"
10-3/4"
13-3/8"
Track
II