Optional Installations; Side Lock (Sold Separately); Doormaster Tm Bracket - Wayne-Dalton TORQUEMASTER 5140 Installation Instructions And Owner's Manual

�

Side lock (Sold Separately)

Tools Needed:
Install the side lock on the second
section of the door. secure the lock to
Power Drill
the section with (4) 1/4"- 20 x 11/16"
self drilling screws. square the lock
7/16" socket
assembly with the door section and
Driver
align with the square hole in the vertical
track. The side lock should be spaced
in approximately 1/8" from the section
edge.
IMPORTANT: sIDE lOCks MusT BE
REMOVED OR MaDE INOPERaTIVE IN
ThE uNlOCkED POsITION IF aN
OPERaTOR Is INsTallED ON ThE DOOR.
NOTE: after completing this step,
continue with step 8 on page 15.
�
DoorMaster
(Supplied with Doormaster
Tools Needed:
NOTE: When installing a DoorMaster
operator use the center bracket and
None
drive gear supplied with your operator
(located in DoorMaster
slide the DoorMaster
gear assembly onto the TorqueMaster
spring tube, so that the drive gear/center
bracket assembly are in the center of
the TorqueMaster
NOTE: after completing this step,
continue with step 18 on page 22.
Tools Needed:
To locate the center bracket, mark the
Power Drill
header halfway between the flagangles
1/8" Drill Bit
and level the TorqueMaster
Drill 1/8" pilot holes into header for the
7/16" socket
lag screws. Fasten the metal bracket to
Driver
the header using (2) 1/4" x 1-1/2" lag
screws.
NOTE: after completing this step,
continue with step 27 on page 28.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
A
bracket/gear
TM
)
™
A
TM
package).
TM
bracket/drive
TM
®
spring tube.
®
b
b
® spring tube.
BRaCkET
BushING
assEMBly
1/8"
(4) 1/4"- 20 x 11/16"
sElF DRIllING sCREWs
TM
DOORMasTER BRaCkET/
DRIVE GEaR assEMBly
TORquEMasTER
®
CENTER
TuBE
(2) 1/4" x 1-1/2"
hEx hEaD laG
sCREWs
31