Optional Installations; Side Lock; Doormaster Tm Bracket - Wayne-Dalton TorqueMaster 9800 Series Installation Instructions And Owner's Manual

D
Install the side lock on the second
Tools Needed:
section of the door. secure the lock to
the section with (4) 1/4"- 20 x 11/16"
Power Drill
self drilling screws. square the lock
7/16" socket
assembly with the door section and
Driver
align with the square hole in the vertical
track. The side lock should be spaced
approximately 1/8" from the section
edge.
IMPORTANT: sIDE lOCks MusT BE
REMOVED OR MaDE INOPERaTIVE IN
THE uNlOCkED POsITION IF aN
OPERaTOR Is INsTallED ON THE DOOR.
NOTE: after completing this step,
continue with step 10 on page 17.
D
DoorMaster
Tools Needed:
NOTE: When installing a DoorMaster
Power Drill
operator use the center bracket and
drive gear supplied with your operator
1/8" Drill Bit
(located in DoorMaster
slide the DoorMaster
gear assembly onto the TorqueMaster
spring Tube, so that the drive gear/
center bracket assembly are in the
center of the TorqueMaster
NOTE: after completing this step,
continie with step 19 on page 25.
Tools Needed:
locate the center bracket, mark the
Power Drill
header halfway between the flagangles
and level the TorqueMaster
1/8" Drill Bit
Drill 1/8" pilot holes for the lag screws.
7/16" socket
Fasten the metal bracket to the header
Driver
using (2) 1/4" x 1-1/2" lag screws.
NOTE: after completing this step, continie
with step 28 on page 31.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Side Lock

Bracket
TM
A
TM
package).
TM
bracket/drive
TM
®
spring Tube.
®
B
DOORMasTER
spring Tube.
®
(4) 1/4"- 20 x 11/16"
sElF DRIllING sCREWs
A
TM
DOORMasTER
DRIVE GEaR assEMBly
TORquEMasTER
B
TM
BRaCkET/
DRIVE GEaR
assEMBly
1/8"
BRaCkET/
TuBE
®
35