AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 100

Upgrading Firmware
FIG. 79
Master Communications Settings dialog box
2.
Click the Communications Settings... button to open the Communications Settings dialog box (FIG. 80).
FIG. 80 Communications Settings dialog box
3.
Click on the NetLinx Master radio button from the Platform Selection section.
4.
Click on the Virtual Master radio box from the Transport Connection Option section to configure the PC
to communicate directly with a panel. Everything else, such as the Authentication, is greyed-out because
this connection is not going through the Master's UI.
5.
Click the Edit Settings button on the Communications Settings dialog to open the Virtual NetLinx Master
Settings dialog (FIG. 81).
FIG. 81 Virtual NetLinx Master Settings
6.
Within this dialog, enter the Master System number. The default is 1.
7.
In the Available Connections section, click on the IP address for the touch panel to select it.
86 MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom