A Special Note For Network Interface Connections - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

12.
Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog.
13.
After the file transfer is complete, the panel will automatically reboot. As the panel is rebooting,
temporarily unplug the USB connector on the panel until the panel has completely restarted.
14.
Once the first panel page has been displayed, reconnect the USB connector to the panel.
15.
Right-click the associated System number and select Refresh System. This causes a refresh of all project
systems, establishes a new connection to the Master, and populates the System list with devices on your
particular system.
16.
Confirm that the panel has been properly updated to the correct firmware version.
Verify you have downloaded the latest firmware file from www.amx.com and then
save the Kit file to your computer.

A Special Note for Network Interface Connections

Due to any USB connection to your PC being made through a Network Interface Connection (NIC), Windows
will automatically make any new NIC connection the Primary connection. If this happens, the USB address of
12.0.0.x will show up across the PC's network switches as the PC's source address. In some cases, network
administrators will notice the NIC connection and reconfigure any PC that has connected to the MVP-5200i.
Business, college, and government installations are the type of installations that would be most affected, and
most home installations would not be affected.
To prevent the NIC connection from becoming the primary connection:
1.
From the Windows Start menu, select Settings > Control Panel to open the Control Panel window.
2.
In the Control Panel window, click on the Network Connections icon to open the Network Connections
window (FIG. 85)
FIG. 85
Network Connections window
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Upgrading Firmware
89