Phn-Setup-Domain; Phn-Setup-Enable; Phn-Setup-Password; Phn-Setup-Port - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

SIP Commands (Cont.)
^PHN-
TRANSFER
Transfers the call
to the provided
number.
The following table lists and describes SIP setup commands. Using any of these commands causes the current
user to go offline.
SIP Setup Commands
^PHN-SETUP-
DOMAIN
Sets the realm for
authentication.
^PHN-SETUP-
ENABLE
Registers a new
user
^PHN-SETUP-
PASSWORD
Sets the user
password for the
proxy server.
^PHN-SETUP-
PORT
Sets the port num-
ber for the proxy
server.
^PHN-SETUP-
PROXYADDR
Sets the IP
address for the
proxy server.
^PHN-SETUP-
STUNADDR
Sets the IP
address for the
STUN server.
^PHN-SETUP-
USERNAME
Sets the user
name for authenti-
cation with the
proxy server.
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Syntax:
"'^PHN-TRANSFER, <connection id>, <number>'"
Variable:
connection id = The identifying number of the connection
number = The number to which you want to transfer the call.
Example:
SEND_COMMAND Panel,"'^PHN-TRANSFER, 1, 2125551000'"
Syntax:
"'^PHN-SETUP-DOMAIN, <domain>'"
Variable:
domain = The realm used for authentication
Example:
SEND_COMMAND Panel,"'^PHN-SETUP-DOMAIN, asterisk'"
Once the configuration has been updated, the ENABLE command should be run to re-
register the new user.
Syntax:

"'^PHN-SETUP-ENABLE'"

Syntax:
"'^PHN-SETUP-PASSWORD, <password>'"
Variable:
password = The password for the user name
Example:
SEND_COMMAND Panel,"'^PHN-SETUP-PASSWORD, 6003'"
Syntax:
"'^PHN-SETUP-PORT, <port>'"
Variable:
port = The port for the proxy server
Example:
SEND_COMMAND Panel,"'^PHN-SETUP-PORT, 5060'"
Syntax:
"'^PHN-SETUP-PROXYADDR, <IP>'"
Variable:
IP = The IP address for the proxy server
Example:
SEND_COMMAND Panel,"'^PHN-SETUP-PROXYADDR, 192.168.223.111'"
Syntax:
"'^PHN-SETUP-STUNADDR, <IP>'"
Variable:
IP = The IP address for the STUN server
Example:
SEND_COMMAND Panel,"'^PHN-SETUP-STUNADDR, 192.168.223.111'"
Syntax:
"'^PHN-SETUP-USERNAME, <username>'"
Variable:
username = The user name (usually the phone extension)
Example:
SEND_COMMAND Panel,"'^PHN-SETUP-USERNAME, 6003'"
Programming
145