AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 165

2.
Make sure to seat fully the battery plug to the connector in the device (FIG. 90). If fingers cannot be used,
use a clean, nonconductive stick or probe to seat the connectors.
3.
Reattach the back of the device, engaging the hook on the lower left of the case (near the speaker) and
using it to swing the back down into place.
When reassembling the device, take especial care not to pinch, puncture, or damage
the battery. Do not force the rear plate onto the device, as this can damage the
device.
4.
Insert the five screws and replace the rubber feet atop the two upper screws, using the replacement rubber
feet and bottom label included in the Battery Pack Kit (FIG. 5).
Back plate
Bottom screw holes
Speaker
FIG. 92 MVP-5200i back plate installation
The three bottom screws are shorter than the top two screws. The screws must be
re-assembled in their original location or the device can be damaged during
reassembly.
5.
Restart the device to confirm that the new battery is functioning correctly.
6.
Attach the residual voltage discharge adaptor (SAA5966-27-A) to the old battery and allow any
remaining charge to dissipate. Note that the adaptor may become warm to the touch for up to 12 hours.
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Rubber feet
Upper screws
Front of MVP-5200i
Battery Life and Replacement
Bottom label
Bottom screws
151