Turning On The Mvp-5200I; Intercom Microphone; Stylus; Kick Stand - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Turning on the MVP-5200i

The MVP-5200i uses one of two methods to turn it on. These use either the navigation wheel or the
touchscreen. To learn which method works for your panel:
1.
Press any of the navigation wheel's compass points and hold until the AMX splash screen appears on the
touchscreen.
2.
If the navigation wheel does not respond, press the touchscreen and hold until the AMX splash screen
appears on the touchscreen.

Intercom Microphone

The MVP-5200i contains a built-in microphone above the upper lefthand corner of the touch screen for video
and audio conferencing capabilities. This microphone is concealed by the casing.

Stylus

The MVP-5200i comes with a unique touchscreen stylus that slides into a storage groove on the right side of
the device when not in use. Replacement styluses may be ordered in a 3-pack (FG5966-30-xx) from
www.amx.com.

Kick Stand

Since the MVP-5200i device is designed to be a unit used away from its charging station, it has an extendable
"kickstand" on the back of the unit (FIG. 2). This may be opened by physically lifting the free end of the kick
stand away from the device. The device may then be propped up on a flat surface and accessed in a normal
fashion.

Audio/Video Capabilities

The MVP-5200i has the capability of displaying multiple JPEG and PNG files at one time. The device also
supports streaming motion JPEG video (of the sort used by many IP and Web cameras), as well as MP3 and
WAV audio files.

Power Management

The MVP-5200i utilizes a dual voltage external power supply. It may be recharged through the supplied PS3.0
Power Supply (FG423-30), as well as through the MVP-TCS-52 Table Charging Station (FG5966-1X) or the
MVP-WCS-52 Wall Charging Station (FG5966-1X). For more information, see the Accessories section on
page 9 for details.
Although the MVP-5200i unit is equipped with a mini-USB port, the device cannot be
powered through the USB port. The port is only used for uploading firmware.
When not in active use, the MVP-5200i conserves battery life between chargings. In its Sleep Mode, the
device's entire system is shut down, with only wakeup systems powered to detect incoming commands or
touch panel contact. Pressing any of the compass points on the navigation wheel will return the device to its
Active Mode,
For more information on the battery, see the Battery Life and Replacement section on page 147.

Cleaning the Touch Overlay, Case, and Navigation Wheel

Always use a clean cotton cloth and a spray bottle containing water or a vinegar-based cleaner to clean the
MVP-5200i, as alcohol-based cleaners can damage the device's touch screen overlay.


MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Do not directly spray the device: instead, spray the cloth to clean the touch screen overlay and
navigation wheel.
Do NOT use an abrasive of any type to clean the MVP-5200i, as this may permanently damage or
remove the device's finish.
Introduction
7