AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 68

Protected Setup Pages
Protected Setup Page (Cont.)
System Recovery:
Reboot/Shutdown Panel:
Docking Station
Channel Code
Channel Port
Level Port
Channel Code
FIG. 55 Function Show example
When the Function Show feature is displayed, the Channel Port and Code will appear
in yellow, the Address Port and Code in green, and the Level Port and Channel Code
in purple.
To reboot the panel:
1.
Access the Protected Setup page.
2.
Press the Reboot button.
3.
Wait until the panel completes its reboot.
4.
Log back into the Protected Setup page, if necessary.
To shut down the panel:
1.
Access the Protected Setup page.
2.
Press the Shutdown button.
3.
Disconnect any power source plugs or USB connections, if necessary.
54
• Reset System Settings - Deletes all of the current configuration parameters
on the panel (including IP Addresses, Device Number assignments,
Passwords, and other presets). This option invokes a Confirmation dialog,
prompting you to confirm your selection before resetting the panel.
• Remove User Pages - Removes all TPD4 touch panel pages currently on the
panel, including the pre-installed AMX Demo pages. This option invokes a
Confirmation dialog, prompting you to confirm your selection before removing
the panel pages.
Note that the YES button on the Confirmation dialog is disabled for 5 seconds
as additional protection against accidentally resetting the panel or removing
the panel pages.
• Pressing the Reboot button causes the panel to reboot after saving any
changes.
• Pressing the Shutdown button causes the panel to shut down after saving
any changes.
• Dock Status - Illuminates when the panel is docked and communicating with
the Charging Station.
• Undock Panel - Releases panel from Wall Mounted Charging Station.
0.20
BUTTON
0,8 0,50
Address Port
Address Code
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom