AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 29

6.
Prepare the captive wires for the 2-pin 3.55 mm mini-captive wire connector used for the MVP-WCS-
52's power supply:
Preparing and connecting the captive wires requires the use of a wire stripper and
flat-blade screwdriver.



7.
Secure the power cable to the device, using either of the two tie-wrap anchors included in the Installation
Kit at the top rear of the device (FIG. 12).
Point the head of each tie wrap toward the center of the device.
Mini-Captive Wire
Connector Plug
(female)
FIG. 12 MVP- WCS-52 - Rear view
8.
Firmly seat the mini-captive wire connector to the power connector on the device.
9.
Firmly seat the device against the box. Make sure that the tab connector at the top of the device is locked
into the box.
10.
Insert the two installation screws from the MVP-WCS-52 Installation Kit into the screw holes in the
interior compartment of the device and tighten them to anchor the device to the box (FIG. 13).
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Strip 0.25 inch (6.35 mm) of wire insulation off all wires.
Insert each wire into the appropriate opening on the connector.
Turn the screws clockwise to secure the wires in the connector. Do not over-torque the screws;
doing so can bend the seating pins and damage the connector.
Tie-Wrap Anchors
Accessories
15