Static Wep Settings - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

5.2" modero viewpoint touch panel with intercom
Hide thumbs Also See for Modero ViewPoint MVP-5200i:
Table of Contents

Advertisement

Open (Clear Text) Settings
SSID (Service Set Identifier):
Save/Cancel:
Refer to the Configuring Wireless Network Access section on page 22 and the Using the Site Survey
Tool section on page 23 for further details on these security options.

Static WEP Settings

Press the Static WEP button to open the Static WEP Settings page (FIG. 61).
FIG. 61
Wireless Settings page - Static WEP Settings
Static WEP security requires that both a target WAP be identified and an encryption method be implemented
prior to establishing communication. In addition to providing both Open and Shared Authentication
capabilities, this page also supports Hexadecimal and ASCII keys.
Static WEP Settings
SSID (Service Set Identifier):
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Opens an on-screen keyboard to enter the SSID name used on the target
WAP. The SSID is a unique name used by the WAP, and is assigned to all
panels on that network. An SSID is required by the WAP before the panel is
permitted to join the network.
• The SSID is case sensitive and must not exceed 32 characters.
• Make sure this setting is the same for all points in your wireless network.
• NXA-WAP200Gs use AMX as their default SSID.
• If this field is left blank, the panel will attempt to connect to the first available
WAP.
• Save - store the new security information, apply changes, and return to the
previous page.
• Cancel - discard changes and return to the previous page.
Opens an on-screen keyboard to enter the SSID name used on the target
WAP. The SSID is a unique name used by the WAP, and is assigned to all
panels on that network. An SSID is required by the WAP before the panel is
permitted to join the network.
• The SSID is case sensitive and must not exceed 32 characters.
• Make sure this setting is the same for all points in your wireless network.
• NXA-WAP200Gs use AMX as their default SSID.
• If this field is left blank, the panel will attempt to connect to the first available
WAP.
Protected Setup Pages
61

Advertisement

Table of Contents
loading

Table of Contents