AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 58

Setup Pages
Setup Page (Cont.)
Connection Status:
Display Timeout:
Inactivity Page Flip
Timeout:
Panel Brightness:
Sleep Blink LED:
44
Displays whether the panel is has external communication, as well as the
encryption status of the Master, the connection type (Ethernet or USB), and to
which System the panel is connected.
• Until a connection is established, the message displayed is: "Attempting via
Ethernet" or "Attempting via USB".
• When a connection is established, the message displayed is either: "Connected
via Ethernet "or "Connected via USB ".
• The word "Encrypted" appears when an encrypted connection is established with
a NetLinx Master.
Note: The panel must be rebooted before incorporating any panel communication
changes and to detect Ethernet connections.
Indicates the length of time that the panel can remain idle before activating display
timeout (sleep mode), causing the LCD turn off. While in sleep mode, unit
maintains wireless communication and LCD wakes immediately upon pressing
overlay.
• Press the Up/Down buttons to increase/decrease the Display Timeout setting.
Range = NONE, 10 sec., 15 sec., 20 sec., 25 sec., 30 sec., 5 mins., 15 mins., 30
mins., 60 mins., 2 hrs.
• Set the timeout value to NONE to disable Sleep mode.
Note: Small timeout values maximize the life of the battery charge.
Advanced Power Settings button: Enabling this button disables various peripherals
that would otherwise remain powered while the device is in Sleep mode, including
the navigation wheel. When this button is enabled, pressing the navigation wheel
center will NOT wake up the panel, and only touching the touch screen will awaken
it. This feature is only active when the device is running on battery power, and is
not active when the device is on external power. When enabled, Advanced Power
Savings allows additional battery life of panel availability without recharging. This
feature is not user-configurable in some firmware versions.
Disable Timeout On External Power button: When enabled, the display will not go
into Timeout when external power is applied. The display always will go into the
preselected Display Timeout setting when on battery power.
Indicates the length of time that the panel can remain idle before automatically
flipping to a pre-selected page.
• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip
Timeout setting. Range = 0 - 240 (minutes).
• Set the timeout value to 0 to disable Inactivity Page Flip mode.
Note: The touch panel page used for the Inactivity page flip is named within a
small Inactivity Page field below the buttons.
Sets the display brightness and contrast levels of the panel.
• Press the Brightness Up/Down buttons to adjust the brightness level.
Range = 0 - 100.
Note: Be careful not to turn down the brightness too low to be able to see the
Setup page.
Enables and disables the blinking of the navigation wheel LED when the device is
in Sleep mode. When enabled, the LED blinks while the device is charging. The
Sleep Blink LED button is enabled by default.
Note: This feature will only apply when the device is in Sleep mode. When the
device is active, the state of the LED will match that of the display.
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom