AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 40

Configuring Communication
FIG. 23 Wireless Settings page - Open (Clear Text) security method
4.
Press the red SSID field to display an on-screen Network Name (SSID) keyboard.
5.
In this keyboard, enter the SSID name used on the target Wireless Access Point (case sensitive).


6.
Click Done when complete.
7.
From the Open (Clear Text) Settings page (FIG. 23), press the Save button to incorporate the new
information into the device and begin the communication process.
8.
Verify the proper configuration in the fields in the IP Settings section. Refer to Step 1: Configure the
Device's Wireless IP Settings section on page 22 for detailed information.
9.
Press the Back button to return to the Protected Setup page and press the on-screen Reboot button to save
any changes and restart the device. Remember that the connection must be configured to a target
Master from the System Settings page.
10.
After the panel restarts, return to the Wireless Settings page's RF Link Info section and verify the link
quality and signal strength:
The descriptions are None, Poor, Fair, Good, Very Good, and Excellent (FIG. 21).
The signal strength field should provide some descriptive text regarding the strength
of the connection to a Wireless Access Point. If no signal or no IP Address is
displayed, configuration of the network could be required.
26
The card should be given the SSID used by the target WAP. If this field is left blank, the unit will
attempt to connect to the first available WAP. By default, all WAP200Gs use AMX as their
assigned SSID value.
One of the most common problems associated with connection to a WAP involves an incorrect
SSID. Make sure to maintain the same case when entering the SSID information. ABC is not the
same as Abc.
Required information:
- SSID (Network Name used by the Target WAP)
By default, this field displays the
SSID - AMX
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom