AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 42

Configuring Communication
FIG. 26 Wireless Settings page - Static WEP security method
5.
Toggle the Encryption field (FIG. 26) until it reads either 64 Bit Key Size or 128 Bit Key Size.
The 64/128 selection reflects the bit-level of encryption security. This WEP encryption level must match
the encryption level being used on the WAP.
WEP will not work unless the same Default Key is set on both the panel and the
Wireless Access Point.
For example: if the Wireless Access Point has been set to default key 4 (which was
01:02:03:04:05), the panel's key 4 must be set to 01:02:03:04:05.
6.
Toggle the Default Key field to choose a WEP Key value (from 1- 4) that matches what will be used on
the target.
The WEP Key identifier values must match for both devices.
7.
Verify that the fields within the IP Settings section have been properly configured. Refer to Step 1:
Configure the Device's Wireless IP Settings section on page 22 for detailed information.
8.
Press the Back button to navigate to the Protected Setup page and press the on-screen Reboot button to
save any changes and restart the panel. Remember that you will need to navigate to the System Settings
page and configure the connection to a target Master.
9.
After the panel restarts, return to the Wireless Settings page to verify the Link Quality and Signal
Strength:

The signal strength field provides some descriptive text regarding the strength of the
connection to a Wireless Access Point. Configuration of the network could be
required if there is no signal or no IP Address is displayed.
28
The descriptions are None, Poor, Fair, Good, Very Good, and Excellent.
Requ ired Information:
- SSI D (Net work Name used by t he Target WAP)
- Encryption Method
- Passphrase
- WEP Key assignment
- Authentication Met hod
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom