AMX Modero ViewPoint MVP-5200i Operation/Reference Manual page 50

Configuring Communication
6.
Click the Edit Settings button in the Communications Settings dialog to open the Virtual NetLinx Master
Settings dialog (FIG. 39).
FIG. 39 Virtual NetLinx Master Settings dialog
7.
From within this dialog, enter the System number (default is 1) and note the IP Address of the target PC
being used as the Virtual Master. This IP Address can also be obtained by following these procedures:



8.
Click OK to close the open dialogs, save the settings, and return to the main NetLinx Studio application.
9.
Click the OnLine Tree tab in the Workspace window to view the devices on the Virtual System. The
default System value is one.
10.
Right-click on the Empty Device Tree/System entry and select Refresh System to re-populate the list.
11.
Place the panel in the Table Charging Station or in the Wall Charging Station and turn the panel On.
12.
After the panel powers up, press and hold down the navigation wheel center button for 3 seconds to
continue with the setup process and proceed to the Setup page.
13.
Select Protected Setup > System Settings (located on the lower-left) to open the System Settings page
(FIG. 40).
FIG. 40 Sample System Settings page (for Virtual Master communication)
14.
Press the blue Type field (from the Master Connection section) until the choice cycles to the word
Ethernet.
15.
Press the Mode field until the choice cycles to the word URL.
36
On the PC, click Start > Run to open the Run dialog.
Enter cmd into the Open field and click OK to open the command DOS prompt.
From the C:\> command line, enter ipconfig to display the IP Address of the PC. This information
is entered into the Master IP/URL field on the panel.
IP Addresses of computer
(also obtained by using the
Star t > Run > cmd command)
The System Number is
assigned to the Master
within the AMX
software application
(these must match)
Enter the IP Address
information of the PC
used as a Virtual
Master
When using a Virtual Master,
there is no need to enter a
username and/or password
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom