Jumper Switch Settings - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
–
–
–
–
–
–
How to read the Graphical Magnet Distances table
Contained in the RADION contact SM Installation Guide is a graphical table along with the X ￚ Y
ￚ Z coordinates graphic. Use the table in conjunction with the graphic to determine desired
distances between the magnet and the transmitter based on the type of installation (wood or
metal).
Notice!
The content in the Installation Guide table applies to EN installations.
8.16.2

Jumper switch settings

You can set the detector to enable or disable various sensitivity settings, depending on the
positioning of the jumper. Refer to this section for desired jumper locations. The following
illustration shows the jumper switch pins, as well as their description.
Notice!
Insert the jumper onto the pin prior to installing the battery. Failure to do so may result in
unexpected operation of the device.
Bosch Security Systems, Inc.
The location of the magnet and transmitter in relationship to the door/window frame
dimensions. Verify you have proper clearance with the latch of the window or door you
are installing the device onto. Failure to do so will make it extremely difficult to access
and open the device for maintenance purposes.
In some cases, you might need an additional spacer when installing the transmitter and
magnet in the corner of a recessed door or window frame to close the gap in height
between the magnet and transmitter.
For additional security, you can use an adhesive with the screws to secure the
transmitters and magnets during installation.
When installing the magnet, verify that the notches in the magnet base, line up with the
notches in the transmitter base, otherwise the magnet and transmitter do not function
effectively.
When installing the magnet base, install the face of the magnet base flush to the surface
edge of the installation location. This prevents damage to the magnet plastic base
whenever a window or door is opened.
Adhere to the distances prescribed in the graphical table found in the graphical
Installation and Operation Guide when installing the magnet adjacent to the transmitter.
System Reference Guide
Device Specifications and Overview | en
2014.09 | 01 | F.01U.306.221
99