Set Point Type; Add A Device; Replace A Device - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
3.6.1

Set Point Type

The control panel selects the default device type based on the point type selection. The
following table lists the default device types that are assigned for a given point type:
Point Type
Perimeter
Interior
Fire Instant
Perimeter Instant RADION glassbreak
User Emergency
24-hour Trouble
All other types
This configures the device type that is displayed in RPS and sets the default alarm mask bits
used to decide how the point status will be treated.
3.6.2

Add a device

When you select this menu option, the control panel initiates discovery mode for RADION
devices which enables the control panel to detect points that are not currently configured in
the RADION Receiver. The control panel periodically repeats the phrase "discovering devices"
until the RADION receiver replies with a point's RFID.
1.
2.
3.
4.
3.6.3

Replace a device

This option is presented when the RFID of a selected point has already been configured. If you
choose this option, the control panel follows the procedure identical to the "To Add a Device"
procedure.
The control panel initiates discovery mode and searches for RFID's that are not currently
configured in the RADION receiver. The control center periodically repeats the phrase
"discovering devices" until the RADION receiver replies with a point's RFID.
1.
2.
Bosch Security Systems, Inc.
Default Device Type
RADION mini door/
window
RADION PIR motion
RADION smoke
RADION CO
RADION repeater
RADION universal TX
While the "discovering devices" message is active, activate the wireless point that you
want to add to the system, or press the [#] to exit discovery mode.
After you activate a point, the receiver should see the point and notify the control panel.
The control panel announces the last 4 digits of the discovered point's RFID and presents
the following choices:
To continue, press [1]. If you choose to continue, the control center announces "Please
wait". During this time, the RFID is saved in the database and configured in the RADION
receiver.
To try again, press [2]. If you choose to try again, the control panel ignores the RFID that
was discovered and returns to the "discovering devices" message.
While the "discovering devices" message is active, activate the wireless point that you
want to add to the system, or press the [#] to exit discovery mode.
After you activate the point, the receiver should see it and notify the control panel. The
control panel announces the last 4 digits of the discovered point's RFID and presents the
following choices:
System Reference Guide
System Installation and Configuration | en
Wireless Alarm Inputs (default)
Magnetic
Motion
Smoke
Glass Break
CO Detector
None
Wired Input
35
2014.09 | 01 | F.01U.306.221