Communicator Programming Items - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
Programming Item
Missing Wireless Device Conditions
Silence Trouble Tones
System Inactivity Time (Hours)
System Inactivity Time (Days)
System Inactivity Time (Weeks)
Force Arm/Exit Error
Audio Verification Command Set
Key Fob Duress
Key Fob Button Configuration
Key Fob Button Configuration
Default = Country-specific default. Select this programming item to hear the updated default value, or refer to
Country Code Specific Default Programming Codes, page 112.
5.2.3

Communicator Programming Items

Notice!
To enable reporting, configure the following programming items:
Account Number (Expert Programming Item Number 100)
Route 1 Primary Destination (Expert Programming Item Number 206)
Format for Route 1 Primary Destination (Expert Programming Item Number 211)
Route Destination Items
Programming Item
Account Number
Phone Line Supervision
Bosch Security Systems, Inc.
Item Selections
Number
162 0 = Creates a tamper condition (required for
EN50131-compliant countries).
1 = Creates a trouble condition.
163 0 = All trouble tones announced
1 = Fire and 24-Hour trouble tones announced
164 0 to 255
165 0 to 255
166 0 to 255
167 0 = Off-normal points create an Exit Error at the
end of Exit Delay
1 = Off-normal points are force armed at the end of
Exit Delay
168 0 = Complies with SIA AV-01-1997.11
1 = Use alternate verification command set
601 0 = Duress event disabled
1 = Duress event enabled
616 0 = Status request only
1 = Turn system on (occupied)
2 = Turn system on (custom protection)
626
3 = Turn output on or off
4 = Turn output on for 2 sec.
Item Selections
Number
100 4 or 6 digits, using 0 to 9 and B to F.
Refer to Report Configuration, page 45 for account
number, phone number, and IP address entry
instructions.
201 0 = Unsupervised.
1 = Supervised.
System Reference Guide
Programming | en 51
Manuf.
Default
0
0
0
0
0
0
0
0
0
Manuf.
Default
000000
0
2014.09 | 01 | F.01U.306.221