Bosch ICP-EZM2 System Reference Manual page 40

40 en | Programming Access Options
2.
3.
Automatic
This option is the primary method for establishing a connection between RPS and the control
panel.
Connect the internal modem on the RPS PC, or an external modem, to the control panel.
Manual Dial
1.
2.
3.
Modem Dial
Use a telephone connected in parallel to the RPS modem and click Connect To in the RPS
Panel Communication Window to dial the premises phone number.
1.
2.
3.
Direct Connect
Select this method to establish a local, on-site connection between the RPS PC (or laptop)
and the control panel.
1.
2.
2014.09 | 01 | F.01U.306.221
Click Connect. The Panel Communication window opens.
Select a connection method from the Connect Via menu that best meets the system's
needs for remote programming. Refer to the following sections for descriptions of each
connection method.
Establishes a phone connection between the control panel and RPS:
– Dial the RPS phone number using the house phone, or connect a test telephone to
the control panel's test posts,
OR
– From the RPS site, use a telephone connected in parallel to the RPS modem and
manually dial the house phone number.
Select Manual Dial as the connection option on the RPS Panel Communication window.
To answer the incoming call, click Connect on the RPS Panel Communication window to
establish a remote connection between RPS and the control panel.
Connect the internal modem on the RPS PC, or an external modem, to the control panel.
When the control panel answers the incoming call, the system announces "Enter your
passcode."
When you hear the control panel modem tones, press the Connect To button on the RPS
Panel Communication window. RPS then sends the DTMF tone to connect to the control
panel.
On the Telco side of the phone line, ensure that Tip and Ring are disconnected.
Connect the internal modem on the RPS PC, or an external modem, to the control panel.
Refer to the figure below.
System Reference Guide
Easy Series Control Panel
Bosch Security Systems, Inc.