User Programming Items - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
Programming Item
Control Center
Backlight Extinguish
Mode
Default = Country-specific default. Select this programming item to hear the updated default value, or refer to
Country Code Specific Default Programming Codes, page 112.
5.2.9

User Programming Items

Programming Item
Passcode Length
Installer Passcode (User 0)
Master User Passcode (User 1)
Duress User (User 22) Enabled
RFID Token Password
Default = Country-specific default. Select this programming item to hear the updated default value, or refer to
Country Code Specific Default Programming Codes, page 112.
Caution!
Do not change the RFID Token Passwords item once tokens are added to the system.
!
Bosch Security Systems, Inc.
Item Number
Control Center 1: 814
Control Center 2: 824
Control Center 3: 834
Control Center 4: 844
Item Selections
Number
861 Set the length of all passcodes
(4 or 6 digits).
7001 Four-digit Range: 1111 to 5555
Six-digit Range: 111111 to 555555
7011
862 0 = Duress user disabled
1 = Duress user enabled
2 = Guard code enabled
Duress User passcode:
Six digits: 111111
Four digits: 1111
863 Use this item to prevent unauthorized copying of tokens
(00000000 to FFFFFFFF).
System Reference Guide
Selections
0 = Always on.
1 = Dim until user presence is
detected.
2 = Off until user presence is
detected.
3 = Off until user presents
token or enters passcode.
Programming | en
Manuf. Default
Control Center 1: 0
Control Center 2: 0
Control Center 3: 0
Control Center 4: 0
Manuf.
Defaul
t
4
5432
54321
1
1234
12345
5
0
12345
678
2014.09 | 01 | F.01U.306.221
61