Apply System Power; Initial System Startup; Configure The System; Upgrade The Control Panel (Optional) - Bosch ICP-EZM2 System Reference Manual

Easy series control panel
Hide thumbs Also See for ICP-EZM2:
Table of Contents

Advertisement

32
en | System Installation and Configuration
Intrusion Point Wiring
You can wire Supervised Points 1 to 32 as wired or wireless intrusion points.
To program Supervised Points 1 to 32 as intrusion points, refer to Points, page 44.
See also
3.3

Apply System Power

Notice!
Because the control panel is permanently connected equipment, a readily accessible
disconnect device must be included into the building installation wiring.
An external earth ground is required to ensure safe and proper system operation. Failure to
ground the system can cause personal injury and degraded system performance, such as
problems with tokens or noise on the control center.
Connect battery power to the control panel. Refer to System Components and Wiring, page 18.
Use a cable tie to secure the incoming AC wires to the enclosure, where required.
3.4

Initial System Startup

1.
2.
Stage
Time Interval
1
0 to15 sec
2
15 to 45 sec
3
45 to 75 sec
4
75 sec
Table 3.2: Initial System Startup Sequence (No RADION devices discovered)
3.5

Configure the System

3.5.1

Upgrade the Control Panel (Optional)

Insert the ICP-EZRU-V4 ROM update key.
2014.09 | 01 | F.01U.306.221
Points, page 44
Outputs, page 46
Points, page 44
Apply AC power to the system.
Refer to the table below for the Initial System Startup sequence.
Control Center
Intermittent flashing green icon
Flashing amber circle
Single rotating amber segment
Solid green circle
System Reference Guide
Easy Series Control Panel
RADION receiver
LED on continuous
slow flash: 1 second
on, 1 second off.
Indicates the receiver is
being programmed with
the zone and
transmitter ID's from
the compatible control
panel.
Bosch Security Systems, Inc.

Advertisement

Table of Contents
loading

Table of Contents