Industry Canada; Sia - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
The REN determines the number of devices that can be connected to the telephone line.
Excessive REN's on the telephone line might result in the devices not ringing in response to an
incoming call. In most, but not all areas, the sum of the REN's should not exceed five. To
determine the number of devices that you can connect to the telephone line, contact the
telephone company for the maximum REN for the calling area.
The telephone company notifies you if this equipment harms the telephone network. If
advance notice is not practical, the telephone company notifies the customer as soon as
possible. Also, you are advised of your right to file a complaint with the FCC if you believe it is
necessary to do so.
The telephone company might make changes in its facilities, equipment, operation, or
procedures that could affect the operation of this equipment. If this happens, the telephone
company provides advance notice so you can make the necessary modifications for
maintaining uninterrupted service.
If you experience trouble with the Easy Series control panel, contact Bosch Security Systems
customer service for repair and warranty information. If the trouble harms the telephone
network, the telephone company might request that you remove the equipment from the
network until the problem is resolved. User repairs must not be made, and doing so voids the
user's warranty.
Do not use this equipment on public coin service provided by the telephone company.
Connection to party line service is subject to state tariffs. Contact your state public utilities
commission for more information.
–
–
1.3

Industry Canada

This product meets the applicable Industry Canada technical specifications.
The ringer equivalence number (REN) for this terminal equipment is 0.0. The REN assigned to
each terminal equipment indicates the maximum number of terminals allowed to be
connected to a telephone interface. The termination of an interface can consist of any
combination of devices subject only to the requirement that the sum of the REN of all devices
does not exceed five.
1.4

SIA

Programming Requirements
To comply with ANSI/SIA CP-01 False Alarm Reduction, set these programming items as
follows:
Programming Item
Intrusion Abort Window
Intrusion Cancel Window
Exit Delay
Entry Delay
Swinger Bypass Count
Auto Protection Level
To comply with ANSI/SIA CP-01 False Alarm Reduction, by default, this system:
–
Bosch Security Systems, Inc.
FCC Registration Number: US:ESVAL00BEZ1; Ringer Equivalence: 0.0B
Service Center: Contact your Bosch Security Systems, Inc. representative for the location
of your service center.
Item Number
110
112
126
127
131
132
Sends Intrusion Alarm Verified and Exit Error reports
System Reference Guide
Agency Approvals and Requirements | en
Default
30 sec
5 min
60 sec
30 sec
1
1
Section Starting Page
System Programming
Items, page 48
2014.09 | 01 | F.01U.306.221
7