Table of Contents
Advertisement
2.
Use
or
displayed.
3.
Press
to move down to the command level within the I/O MENU, "1: GPIB ADDR" will be
displayed.
4.
Use
or
displayed.
5.
Press
to move down a level to set the baud rate.
6.
Use
or
7.
Press Auto (ENTER) to confirm the selection. The message "CHANGE SAVED" will be displayed to
show that the change is now in effect. DMM will exit the parameter level and move up a level to the
command level.
Press Shift →
8.
5.2.4
Selecting the Parity Mode
The instrument has three kinds of parity modes: NONE, EVEN, ODD.
Perform the following steps to select a Parity mode:
Press Shift →
1.
2.
Use
or
displayed.
3.
Press
to move down to the command level within the I/O MENU, "1: GPIB ADDR" will be
displayed.
4.
Use
or
5.
Press
to move down a level to set the parity mode.
6.
Use
or
7.
Press Auto (ENTER) to confirm the selection. The message "CHANGE SAVED" will be displayed to
show that the change is now in effect. DMM will exit the parameter level and move up a level to the
command level.
Press Shift →
8.
5.2.5
Selecting the Terminal Character
The instrument has three kinds of terminal characters: <LF>, <CR> and <LF><CR>.
Perform the following steps to select the terminal characters:
Press Shift →
1.
2.
Use
or
displayed.
3.
Press
to move down to the command level within the I/O MENU, "1: GPIB ADDR" will be
displayed.
4.
Use
or
displayed.
5.
Press
to move down a level to set the terminal character.
6.
Use
or
key to move across to the I/O MENU on the menu level, "E: I/O MENU" will be
key to move across to the BAUD RATE command, "3: BAUD RATE" will be
key to select a baud rate.
key to exit from the menu and return to the measurement status.
to enter the menu on the menu level, "A: MEAS MENU" will be displayed.
key to move across to the I/O MENU on the menu level, "E: I/O MENU" will be
key to move across to the PARITY command, "4: PARITY" will be displayed.
key to select a parity mode.
key to exit from the menu and return to the measurement status.
to enter the menu on the menu level, "A: MEAS MENU" will be displayed.
key to move across to the I/O MENU on the menu level, "E: I/O MENU" will be
key to move across to the terminal character command, "5: TX TERM" will be
key to select a terminal character.
ABM-4082
51
Advertisement
Table of Contents
