Aktakom ABM-4082 User Manual page 66

ABM-4082
:PERCent <NRf>
Command syntax:
:CALCulate[1]:KMATh:PERCent <NRf>
Command Parameter:
<NRf> = -1e6 to1e6
Query:
:PERCent?
Description:
This command is used to specify the target value for the percent calculation.
:ACQuire
Command syntax:
: CALCulate[1]:KMATh:PERCent:ACQuire
Description:
This action command is used to acquire the present input signal reading and use it as the target value
for the PERCent calculation.
:STATe <b>
Command syntax:
:CALCulate[1]:STATe <b>
Command Parameter:
<b> = 0 or OFF
1 or ON
Query:
:STATe?
Description:
This command is used to enable or disable the CALC1 calculation. When enabled, each instrument reading
will reflect the selected calculation.
:DATA?
Command syntax:
:CALCulate[1]:DATA?
Description:
This query command is used to read the result of the CALC1 calculation. If CALC1 is disabled or
NONE is selected, the "raw" reading will be read.
:CALCulate2
These commands are used to configure and control the CALC2 operations on readings stored in the
66
Specify target value.
Query percent target value
Disable CALC1 calculation.
Enable CALC1 calculation.
Query state (ON or OFF) of CALC1.