Table of Contents
Advertisement
Use following steps for display control settings:
Press Shift →
1.
2.
Use
or
displayed.
3.
Press
to move down to the command level within the SYS MENU, "1: RDGS STORE" will be
displayed.
4.
Use
or
5.
Press
to move down a level to set the display control.
6.
Use
or
7.
Press Auto (ENTER) to confirm the selection. The message "CHANGE SAVED" will be displayed to
show that the change is now in effect. DMM will exit the parameter level and move up a level to the
command level.
Press Shift →
8.
4.5.5
Key Sound
To avoid mis-operation, Model DMM has key sound function and you can enable or disable it. Factory
default setting is enabled. The key sound state is stored in non-volatile memory and does not change when
power has been off or after a reset.
Use following steps for key sound setting:
Press Shift →
1.
2.
Use
or
displayed.
3.
Press
to move down to the command level within the SYS MENU, "1: RDGS STORE" will be
displayed.
4.
Use
or
displayed.
5.
Press
to move down a level to enable or disable the key sound.
6.
Use
or
7.
Press Auto (ENTER) to confirm the selection. The message "CHANGE SAVED" will be displayed to
show that the change is now in effect. DMM will exit the parameter level and move up a level to the
command level.
Press Shift →
8.
4.5.6
Self-test
The system Self-test is used as diagnostic tools to locate problems quickly for maintenance man.
A power-on self-test occurs automatically when you turn on Model DMM to assure you that the multimeter is
operational. Power-on self-test is only part of self-test and does not include analog circuit self-test. Please
refer to maintenance guide for the use and relative information about self-test.
to enter the menu on the menu level, "A: MEAS MENU" will be displayed.
key to move across to the SYS MENU on the menu level, "D: SYS MENU" will be
key to move across to the DISPLAY command, "7: DISPLAY" will be displayed.
key to select ON or OFF for the front panel display.
key to exit from the menu and return to the measurement status.
to enter the menu on the menu level, "A: MEAS MENU" will be displayed.
key to move across to the SYS MENU on the menu level, "D: SYS MENU" will be
key to move across to the KEY SOUND command, "8: KEY SOUND" will be
key to turn ON or turn OFF the key sound.
key to exit from the menu and return to the measurement status.
ABM-4082
45
Advertisement
Table of Contents
