Table of Contents
Advertisement
ABM-4082
To save present settings as user's setting, please follow steps below:
Press Shift →
1.
2.
Use
or
displayed.
3.
Press
to move down to the command level within the SYS MENU, "1: RDGS STORE" will be
displayed.
4.
Use
or
displayed.
5.
Press
to move down a level to select a file to save.
6.
Use
or
7.
Press Auto (ENTER) to save the present setting to the selected file. The message "FILE SAVING" and
"SAVE SUCCEED" will be displayed. DMM will exit the parameter level and move up a level to the
command level.
Press Shift →
8.
4.5.3
Restore Settings
Use the following steps to restore factory default setting (Described in Chapter 2) or user saved
configuration (FILE-0 to FILE-9):
Press Shift →
1.
2.
Use
or
displayed.
3.
Press
to move down to the command level within the SYS MENU, "1: RDGS STORE" will be
displayed.
4.
Use
or
displayed.
5.
Press
to move down a level to select a file to restore.
6.
Use
or
FILE-9).
7.
Press Auto (ENTER) to restore the selected setting. The message "FILE LOADING" and "LOAD
SUCCEED" will be displayed. DMM will exit the parameter level and move up a level to the command
level.
Press Shift →
8.
4.5.4
Display Control
To speed up measurement rate for remote control, Model DMM allows user to turn off the front panel display.
You can also turn on the front panel display at remote control.
When the front panel display is turned off, readings are not sent to the display and some display
annunciators still can be displayed. Front panel operation is unaffected by turning off the display.
The display is enabled when power has been off or after a remote interface reset.
44
to enter the menu on the menu level, "A: MEAS MENU" will be displayed.
key to move across to the SYS MENU on the menu level, "D: SYS MENU" will be
key to move across to the SAVE CNFG command, "5: SAVE CNFG" will be
key to select a file from FILE-0 to FILE-9.
key to exit from the menu and return to the measurement status.
to enter the menu on the menu level, "A: MEAS MENU" will be displayed.
key to move across to the SYS MENU on the menu level, "D: SYS MENU" will be
key to move across to the LOAD CNFG command, "6: LOAD CNFG" will be
key to select the factory default setting or user saved configuration (FILE-0 to
key to exit from the menu and return to the measurement status.
Advertisement
Table of Contents
