Table of Contents
Advertisement
1:RDGS STORE → 2:RDGS COUNT → 3:SAVED RDGS → 4:BEEP →5:SAVE CNFG
→ 6:LOAD CNFG → 7:DISPLAY → 8:KEY SOUND → 9:TEST
1. RDGS STORE
2. RDGS COUNT
3. SAVED RDGS
4. BEEP
5. SAVE CNFG
6. LOAD CNFG
7. DISPLAY
8. KEY SOUND
9. TEST
E：Input / Output MENU
1:GPIB ADDR → 2:INTERFACE → 3:BAUD RATE→ 4:PARITY→ 5:TX TERM→ 6:RETURN
1. GPIB ADDR
2. INTERFACE
3. BAUD RATE
4. PARITY
5. TX TERM
6. RETURN
F：CALibration MENU
1:SECURED → [1:UNSECURED] → [2:CALIBRATE] → 3:CAL DATE → 4:CAL COUNT
1. SECURED
2. UNSECURED
3. CALIBRATE
4. CAL DATE
5. CAL COUNT
1
The commands enclosed in square brackets ([ ]) are "hidden" unless the multimeter is UNSECURED for calibration.
Enable or disable reading memory.
Set the number of readings to be saved (2 to 512).
Recall readings stored in memory.
Enable or disable the beeper function
Save the present configuration as one of the 10 user's settings.
Restore factory or one of the 10 user's settings
Enable or disable the front panel display.
Enable or disable the key sound when you press a key.
Perform a complete self-test.
Set the GPIB bus address (0 to 31)
Select one between GPIB and USB as the remote control interface.
Select the baud rate for RS232C(USB) operation.
Select the parity mode for RS232C(USB)
Select the terminal character for RS232C(USB) communication
Enable or disable the command characters RETURN function.
1
The multimeter is secured against calibration; Enter code to unsecure.
The multimeter is unsecured for calibration; Enter code to secure.
Perform complete calibration of present function when UNSECURED.
Read the date for the latest calibration.
Read the total number of times the multimeter has been calibrated.
ABM-4082
13
Advertisement
Table of Contents
