Aktakom ABM-4082 User Manual page 60

ABM-4082
Table 6-1 Signal Oriented Measurement Command Summary
Command
MEASure:<function>?
:CONFigure:<function>
:FETCh?
:READ?
MEASure command
Command syntax:
:MEASure:<function>?
Command parameter :
<function> = VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
RESistance
FRESistance
FREQuency
PERiod
DIODe
CONTinuity
Description:
This command combines all of the other signal oriented measurement commands to perform a
"one-shot" measurement and acquire the reading.
When this command is sent, the following commands execute in the order that they are presented.
:ABORt
:CONFigure:<function>
:READ?
When :ABORt is executed, if continuous initiation is disabled, the instrument goes into the idle state.
If continuous initiation is enabled, the operation re-starts at the beginning of the Trigger Model.
When :CONFigure is executed, the instrument goes into a "one-shot" measurement mode.
When :READ? is executed, its operation will then be performe. In general, another :ABORt is
performed, then an :INITiate, and finally a FETCh? to acquire the reading.
CONFigure Command
Command syntax:
:CONFigure:<function>
60
Function Description
Perform an :ABORt, :CONFigure:<function>, and a :READ?
Configure DMM in a "one-shot" measurement mode for a
specified function.
Request the latest reading.
Perform an :ABORt, :INITiate, and a :FETCh?
DC voltage
AC voltage
DC current
AC current
2-wire resistor
4-wire resistor
Frequency
Period
Diode testing
Continuity test