Table of Contents
Advertisement
→
Shift
→
Shift
Auto
(ENTER)
Trig
(ESC)
4.
Range and measurement speed keys
Auto
Shift
→
Shift →
Shift → Auto
5.
Trig/Hold Key
Trig
Shift → Trig
6.
Shift/Local keys
Shift
Shift (LOCAL) Cancel GPIB or RS232C remote control mode and back to the LOCAL mode..
2.2
Annunciators on Screen
* (asterisk)
Reading being stored
(Diode)
Instrument is in diode testing function
(Speaker)
Beeper on for continuity testing function
4W
Multimeter is in 4-wire resistance function.
ADRS
Multimeter is addressed to listen or talk over the GPIB interface
AUTO
Auto ranging enabled
ERR
Hardware or remote control error detected
Open/Close menu
Recall the menu performed last time.
Move through selections within menu level, command level or parameter level
Move through selections within menu level, command level or parameter level.
Move up a level.
Move down a level.
Save the change made on "parameter" level, and return to the "command" level.
Cancel the change made on "parameter" level, and return to the "command" level.
Select a higher range and disable auto ranging.
Select a lower range and disable auto ranging.
Toggle between auto ranging and manual ranging.
Set measurement speed to Fast.
Set measurement speed to Medium.
Set measurement speed to Slow.
Trigger a measurement from the front panel.
Hold a stable reading on the display when selected numbers of samples are within
the selected tolerance.
Used to access shifted keys.
Figure 2-2
Display Annunciators
ABM-4082
11
Advertisement
Table of Contents
