AMM-1022 1. SAFETY INFORMATION WARNING To ensure safe operation, and in order to exploit to the full the functionality of the meter, please follow the directions in this section carefully. This multimeter has been designed according to IEC-1010 concerning electronic measuring instruments with an overvoltage category CAT II 1000V, CAT III 600V and pollution 2.
Page 4
AMM-1022 - Full compliance with safety standards can be guaranteed only if used with test leads supplied. If necessary, they must be replaced with the same model or same electric ratings. 1.2 DURING USE - Before using, you must select the right input jack, function and range.
Page 5
AMM-1022 1.3 SYMBOL Caution: refer to the instruction manual. Incorrect use may result in damage to the device or its components. Earth This instrument has double insulation. Fuse: F 200mA/250V 1.4 MAINTENANCE - Please do not attempt to adjust or repair the meter by removing the rear case while voltage is being applied.
AMM-1022 2. DESCRIPTION - This meter is a portable professional measuring instrument with handsome LCD easily reading. - Single operation of a transform switch makes measurement convenient. Overload protection and low battery indication are provided, this meter is ideal for use in the fields, workshop, school, hobby and home applications.
AMM-1022 Reversed DC Voltage: approx. 2.8V Overload protection: 250V DC or 250V AC rms 3.2.7 Audible continuity test Built-in buzzer sounds if resistance is less than approx. 50Ω. Open circuit voltage: approx. 2.8V Overload protection: 250V DC or 250V AC rms 3.2.8 Temperature...
AMM-1022 To avoid electrical shock and/or damage to the instrument, do not attempt to take any voltage measurement that might exceeds 1000Vdc or 750Vac rms. Do not apply more than 1000Vdc or 750Vac rms between the common terminal and the earth ground.
AMM-1022 beforehand, set the range selector at the highest position. - “ ” means the socket of INPUT maximum current is 200mA, over current will destroy the fuse. 10A’s maximum current is 10A, no fuse protection. 4.3 Resistance measurement - Connect the black test lead to the COM jack and the red test lead to the Ω...
AMM-1022 the cathode of the diode under testing. - The meter will show the approx. forward voltage of the diode. If the lead connection is reversed, only figure "1" displayed. To avoid electrical shock and/or damage to the instrument, disconnect circuit power and discharge all high-voltage capacitors before testing diodes.
AMM-1022 plug to the COM jack and the red one to the TEMP jack, touch the end of the temperature sensor to the area or surface of the object for measurement. - You can get reading from LCD. To avoid electrical shock, do not connect the thermocouples with the electriferous circuit.
AMM-1022 5. MAINTENANCE 5.1 General Maintenance Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or solvents. Dirt or moisture in the terminals can affect readings. To clean the terminals: - Turn the meter off and remove all test leads.
Page 17
AMM-1022 5.3 Battery replacement To replace the battery (see the Figure): - When the battery voltage drop below proper operation range the symbol will appear on the LCD display and the battery need to be replaced. - Turn the meter off and remove all test leads.
Page 18
AMM-1022 CAUTION Using this appliance in an environment with a strong radiated radio-frequency electromagnetic field (approx. 3V/m), may influence its measuring accuracy. The measuring result can be strongly deviating from the actual value.