Aktakom ABM-4082 User Manual page 89

:CONTinuous?
Description:
When continuous initiation is selected (ON), the instrument is taken out of the idle state. At the
conclusion of all programmed operations, the instrument returns to the top of the trigger model.
NOTE: With continuous initiation enabled (ON), you cannot use the :READ? command or set
sample count greater than one (see:SAMPle:COUNt).
:ABORt Command
:ABORt
Description:
When this action command is sent, Model DMM aborts operation and returns to the top of the Trigger
Model.
:TRIGger
TRIGger subsystem commands are used for the instrument settings of trigger mode, trigger delay and
trigger a measurement.
:SOURce <name>
Command Syntax:
TRIGger:SOURce <name>
Command parameter:
<name> = IMMediate
BUS
MANual(EXTernal)
Query:
:SOURce?
Description:
These are used to select the event control source.
:DELay <n>
Command Syntax:
:TRIGger:DELay <n>
Command parameter:
<n> = 0 to 60000
MINimum
MAXimum
Query:
:DELay?
Description:
This command is used for delay operation of the trigger model. The delay time can also be set by using
Query continuous initiation
instrument default setting is internal trigger)
Triggered via RS232 interface of GPIB interface)
(Press Trig in the front panel for Trigger)
Query control source)
Specify delay in
Specify delay of 0S
Specify delay of 60S
Query the programmed delay
ABM-4082
89