Chapter 5. Changing The Default Settings - Aktakom AM-1108 User Manual

Introduction
The meter allows you to change the default-operating configuration of the meter by changing setup options made at the
factory.
Many of these setup options affect general meter operations and are active in all functions. Others are limited to one function
or group of functions.
Selecting Setup Options
To enter the Setup mode, turn the meter on and press
In the Setup mode, each setup option appears in the secondary display and the default value appears in the primary display.
Press to change the setup option. Press
item has been stored).
To exit the Setup mode, power off.
Selection
Power off time
Backlight time
dBm reference
value
LOG mode
starting time
LOG mode
interval time
COMP mode
selection
Restore factory
default
www.tmatlantic.com

Chapter 5. Changing the Default Settings

to store the set value (SAVE on the primary display indicates the maintained
Table 5-1.Changing the Default Settings
Set Range: 0 to 60min, ±10min for each change.
Set zero to cancel auto power-off function.
Use or to increment or decrement digit.
Set Range: 0 to 9000s, ±30s for each change.
Set zero to cancel auto backlight function.
Use or to increment or decrement digit.
Use or to select reference value: 50Ω, 75Ω, 93Ω, 100Ω, 150Ω,
300Ω, 600Ω 800Ω, 1200Ω, 2400Ω
Set Range: 0 to 3000 min.
Press blue button ( ) to select the set digits.
Use or to change the numerical value of the set digits.
Set Range : 0 to 7200S.
Press blue button（ ）to select the set digits.
Use or to change the numerical value of the set digits.
Set upper or lower outer save value (YES) or upper or lower inner (NO) save
value.
Use or to select.
Press , " " appears in the primary display to indicate return to the
factor default.
.
Function
- 23 -
Factory
Default
10
minutes
30
seconds
600Ω
0
minute
1
second
NO
- - - -