Keypad Commands - Christie CineIPM-2K User Manual

Keypad Commands

Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
Specific keypad commands are explained below:
Power ON/OFF
With the main power switch set to
toggle the Cine-IPM 2K on or off with a single keystroke. Or press and release
followed immediately by
(useful if you are unsure of the present state). Alternatively, press
from the present on/off state.
NOTE: During Cine-IPM 2K power-up, the internal fan powers up and the Status
Display window displays "Powering Up" along with input frequency data or "No
Signal" or error. The TPC will be able to detect the Cine-IPM 2K at this point.
Test
Test
Press to scroll through the Cine-IPM 2K's internal test patterns in order,
Test
including the current input. Or use
in either direction.
Auto
Auto
Setup
Press Auto (a.k.a. "Auto Setup") to initiate an automated process in which the Cine-
IPM 2K optimizes critical display parameters such as size, position, pixel tracking,
etc., for the current source. These parameters are listed in Table 3.1. An Auto Setup
can save time in perfecting a display, and you can modify the adjustments as desired.
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
NOTE: You must have an unlocked channel present to use Auto Setup.
Press to display summary information about the current menu or highlighted
Help Help
menu option. Or, if there is no menu present, press
help topics. To exit any help text, press
Channel
Chan
Press to select a specific source setup (channel) defined and stored in Cine-IPM 2K
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE:
key behavior during a presentation depends on whether or not the
Chan
Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
, press and hold
On
(on) or (off) to guarantee the correct toggle
to scroll only the test patterns (no input)
Table 3.1. Auto Setup
What an "Auto Setup" Does
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
again (or
Help
), the display will automatically change and update
OPERATION
for a second or two to
to access a list of general
Help
).
Exit
, or you may prefer to
Chan
to toggle
3-5