Christie CineIPM-2K User Manual page 8

INSTALLATION AND SETUP
Step 3
2-2
2.2). Alternatively, move the ears to their rear mounting location to position
the Cine-IPM 2K so that its front panel remains accessible and flush with the
rear of the CP2000 pedestal. Always use 4 screws to mount the ears.
2.
INSTALL THE Cine-IPM 2K:
of the Cine-IPM 2K into the open area of
the pedestal. Use 2-4 screws to secure
each mounting ear to the pedestal frame.
3. Re-install the 2 rack protector posts.
Connect Sources
Connect your desired sources to the appropriate connectors on the front input panel
of the Cine-IPM 2K. For more information, see 2.2, Connecting Sources.
•
INPUT 1
•
INPUT 2
•
INPUT 3
•
INPUT 4
•
INPUT 5
•
INPUT 6
*NOTE: Extra video is only available with models that have a BNC
connector at
INPUT 3
include a RCA
connector at that input.
In a recessed installation, pass
the source cable ends through
the ears and down to exit via the
front toe of the pedestal, then
connect at the source (Figure
2.3).
See the CP2000 User's Manual
for further cable routing details.
Insert the rear
– RGB input or Extra Video* via BNC connectors
– Digital or analog signals (DVI-I) from a computer
– Composite video
– S-video
– optional input module #1
– optional input module #2
and will not work with previous Christie models, which
Figure 2.3. Suggested Cable Routing
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)