Christie CineIPM-2K User Manual page 28

OPERATION
3-2
Communications
(FRONT)
Connect all external communication links here, such as a wired keypad, Ethernet,
and/or a serial link from your PC or another Cine-IPM 2K. See Section 2 for details
of connection and setup of all communications.
Connect an RS232-compatible PC or other controller for typical serial
RS232:
communication to and from the Cine-IPM 2K. These in-out ports also provide
loop-through connection to additional Cine-IPM 2Ks, creating a serial
network, and are used for downloading new software to the Cine-IPM 2K.
Connect an RS422-compatible controller for unusually long-distance
RS422:
serial communication.
Connect the desired GPIO-compatible device here for integration of the
GPIO:
Cine-IPM 2K with an established control system. Devices connected via GPIO
can operate in tandem with Cine-IPM 2K, or vice versa and is often used for
automation of regularly scheduled events.
REMOTE KEYPAD:
use a keypad for controlling a Cine-IPM 2K, such as one that is recessed and
hidden inside the CP2000 pedestal. In such cases, the cable is typically routed
out the front toe of the pedestal.
Connect to an Ethernet network with other equipment such as
ETHERNET:
controllers and additional projectors.
Standard and Optional Inputs
Connect all desired non-cinema input sources here. See Section 2 for more
information about connecting sources, and refer to Section 6 for specifications.
Status Display
Full status and error messages appear in this window.
IR Sensor
The IR sensor detects commands from the Cine-IPM 2K IR remote keypad. Turn this
response on or off in the Communications menu.
Main Power Switch
When switched to , the Cine-IPM 2K is ready for power-up and the Status Display
On
window is functional—it shows "Power Off" until you press
When switched to , the Cine-IPM 2K is disconnected from AC (similar to
Off
unplugging the unit) and cannot be detected by the TPC.
AC Connector and Line Cord
Use the Cine-IPM 2K line cord for any installation. Plug into an appropriate wall
outlet or use the convenience outlet in the CP2000 pedestal. The Cine-IPM 2K is
rated for 100-240 VAC—see Section 6, Specifications for more information.
Outputs and Communications to CP2000
All links to the CP2000 and/or other display device are routed from the rear of the
Cine-IPM 2K.
DVI #1 and DVI #2:
located on its rear panel—connect DVI-1 or both of these outputs to the
CP2000 and/or other display device (two DVI cables provided). See 2.3,
Connecting DVI Outputs for details.
Connect the wired (tethered) remote keypad if you want to
(REAR)
The Cine-IPM 2K sends output through identical DVI ports
on the keypad.
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)