Christie CineIPM-2K User Manual page 16

INSTALLATION AND SETUP
2-10
1. In the Cine-IPM 2K
Configuration menu, select
the Output Format submenu.
2. Select the desired "Output
Format"— use "Single Link
8-bit" or "Twin Link 10-bit".
The latter improves displays
of digital progressive source
data.
The Cine-IPM 2K outputs all
sources according to the
choice set here.
3. In the TPC, go to the Custom menu (password required). Set "Input" to the
current DVI route:
For 8-bit mode via a DVI-1 connection, select "DVI-A"
For 8-bit mode via a DVI-2 connection, select "DVI-B".
For 10-bit mode via a double connection, select "DVI-TWIN".
Figure 2.14. TPC Settings
4. Still in the TPC Custom menu, set "Data Format" to match the Cine-IPM 2K
format chosen in Step 2.
NOTE: When using the Cine-IPM 2K with two display devices, both outputs are 8-bit
duplicates of one another and 10-bit mode is not available.
For complete setup information and control of other Cine-IPM 2K options such as
resolution, refer to 2.5, Setting Up the TPC for Source Selection. See also Section 3.
Figure 2.13
(10-BIT EXAMPLE)
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)