Using The Keypad - Christie CineIPM-2K User Manual

3.2 Using the
Keypad
As IR Remote
As Wired Remote
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
The Cine-IPM 2K's rear Ethernet port is currently non-functional.
ETHERNET:
If you will want to select your Cine-IPM 2K inputs using the Touch
RS232 "B":
Panel Controller on the CP2000, you must connect the Cine-IPM 2K's RS232
cable between the rear RS232 "B" port on the Cine-IPM 2K and the RS232
"B" port on the CP2000. This custom Christie-proprietary cable enables
communication between the Cine-IPM 2K processor and the CP2000 so that
you can 1) use the TPC to switch Cine-IPM 2K sources and 2) obtain Cine-
IPM 2K status updates.
Do not use RS232 "B" ports and cable with other
equipment or in other configurations.
Mounting Ears (2)
Mounting ears enable the Cine-IPM 2K to be installed in the rear of the CP2000
pedestal, or rack-mounted in a separate standard 19-inch rack. To recess the Cine-
IPM 2K, position its ears as far forward as possible before installation—this creates a
convenient gap for routing your external connections away from the front panel.
Make sure to secure each ear with 4 screws. Or move the ears fully back for a flush-
front installation.
Rear Mounts
If the Cine-IPM 2K is installed in the CP2000 pedestal, add support strapping
between the pedestal frame and the two rear mounts at the rear corners of the Cine-
IPM 2K.
All functions in the Cine-IPM 2K can be controlled and adjusted using the remote
keypad—refer to the key descriptions provided for the IR remote (Figure 3.2). Use
either as a wireless IR remote or convert to wired use.
The IR remote keypad uses wireless communications from a battery-powered
infrared (IR) transmitter to control the Cine-IPM 2K. Direct the keypad toward the IR
sensor on the Cine-IPM 2K front panel.
The IR remote converts into a wired remote with the addition of a cable (supplied)
which connects to the front of the Cine-IPM 2K. You must also select the "Wired
Keypad" option in the Communications menu. Use a wired remote when lighting
conditions interfere with proper IR transmission, or when the IR sensor is
inaccessible, such as when the Cine-IPM 2K is secured within a closed CP2000
pedestal.
NOTE: Keep batteries in the keypad for powering the laser pointer.
IMPORTANT
OPERATION
3-3